Medion Navigation UnitNavigation Unit Manual de usuario descargar pdf (Pagina 26)

Operating the GoPal

navigation software

Starting and displaying navigation

Directly after entering or selecting the desired route, you can start calculation and thus navigation

for this route.

Tip

You can also start the current navigation using the Start navigation button in the navi-

gation menu. During navigation the Stop navigation appears instead. Use this button to

end the current navigation.

Once navigation has been started, your navigation system switches to the map view. The calcu-

lated route is displayed there and compared to your current position in real time.

In split-screen mode the planned route is displayed as follows in the map view:

• The route is displayed in a map section oriented to the north. You can switch the map display

from 2D to a 3D view using the button if needed. The following display modes are available:

o The map is displayed in a two-dimensional view. If you have set map view to Map in di-

rection of travel in the Settings > Display menu, the map is always oriented to the direc-

tion of travel.

o If you have set the map view to North up in the Settings > Display menu, the map is al-

ways oriented to the north.

o If you have selected the Optimized option, the map is oriented to the north for low levels

of zoom and in the direction of travel for higher levels of zoom (see also Adjusting the dis-

play).

o In the mode 3D map, the map is tilted and three-dimensional. The three-dimensional dis-

play is always oriented to the direction of travel.

Tip

In the two-dimensional display modes, you can manually move the current map section

by tapping a position within the map, holding it down and moving it in the desired direc-

tion: The map section is automatically adjusted. This function is not available in the three

dimensional mode!

• The map section is displayed on the right side of the screen. Two options in split-screen are

available on the left side:

o If the Point of interest button is active, you can select the two closest points of interest di-

rectly using the two buttons located above. You can determine which point of interest cat-

egories should be displayed with the menu Settings > Display > Points of interest settings.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 54 55

Sin comentarios

Medion Navigation UnitNavigation Unit Manual de usuario Pagina 26