Medion Navigation UnitNavigation Unit Manual de usuario descargar pdf (Pagina 21)

Operating the GoPal

navigation software

• Using the button, you start the calculation for navigation. Here you have other available op-

tions that are described in the next section.

Route manager

Using the Route manager button in the Navigation menu, you have the option to plan and simu-

late routes in advance, request current route information or redirect navigation by manually block-

ing route sections.

Route planning

Using the Route planning you can plan your route in advance or change and/or optimise a route

already planned. In addition, this menu allows you to save frequently used tours and load them at

a later time.

Tip

If you need to change your entries during the journey, stop your vehicle at a suitable

point (parking spot etc.).

Entering the start position

There are no places saved on your navigation device when it comes from the factory that can be

used as a start position for a new route.

Proceed as follows to create a starting point for the route:

1. Tap on the list entry Last known position on the menu screen Change route: The menu New

destination opens.

2. Enter a new destination: this process is described in Chapter 3: Operating the GoPal® naviga-

tion software. Close the entry on the Detailed information screen using the button.

The destination entered will now be used as the starting position for the tour and is displayed as

the top entry in the list in the Change route menu.

Adding a destination

Using the Add destination button on the lower edge of the screen, you can enter more route des-

tinations. Entering an additional destination is identical to entering your starting position (see

above). Once it is entered, the new destination is displayed as the next destination in the list in the

Change route menu. Repeat this process to enter more destinations which will then be inserted in-

to the list in the order they are entered. If you have created more than four destinations, you can

browse through the list using the and buttons.

When you tap a destination in the list, it is displayed on the Detailed information screen on an

overview map along with the stored address data or coordinates. Use the button to return to

the Change route menu.

Editing the entries in the route list

You can delete the entries in the route list at any time as required or change the order of the en-

tries in the list to alter the course of the route. Proceed as follows to delete an entry from the list:

• Tap the button for the respective destination: The entry is deleted from the list. Unless the en-

try was the final destination on the route, all subsequent destinations move one position for-

ward.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 54 55

Sin comentarios

Medion Navigation UnitNavigation Unit Manual de usuario Pagina 21